Page 1387 - Furniture Cabinetry Hardware-FloorKitchenResource.com

Consumables and Tools
Adhesives

Titebond ®

→ Cold Press Veneer → UA 920 Sealant

> Economical alternative to contact cement > Permanently flexible and airtight, water-resistant seal
> Formulated to minimize “bleed-through” > Excellent adhesion to most building materials
> Moderate speed of set > Ideal for interior/exterior applications
> No harmful vapors > Soap and water clean-up
> Nonflammable > Paintable with water-based (latex-based) paints
> VOC-compliant
APPLICATION GUIDELINES > Mildew resistant
Application temperature: Above 50°F > UV resistant
Open assembly time: 15 minutes (70˚F/50% RH) > Suitable for all climates
Total assembly time: 15–20 minutes (70˚F/50% RH) > No priming or mixing required
Minimum required spread: Approximately 6 mils or 250 square > 50% total joint movement
feet per gallon. > 800% elongation
Required pressure application: 100–250 psi, depending
on substrates. APPLICATION GUIDELINES
Methods of application: For most consistent coverage a Application temperature: Above 40°F
mechanical spreader is recommended. Service temperatures: -40°F–180°F
Cleanup: Damp cloth while glue is wet. Scrape off and sand Methods of application: Cartridge/caulking gun
dried excess. Working time: Approximately 15 minutes for a 1/4” bead.
Working surfaces: For best results, surfaces must be cleaned
LIMITATIONS down to the original substrate, dry and free from any material that
Titebond Cold Press for Veneer is specifically designed for veneering may deter adhesion.
and is not suited for other types of assembly applications. Not Cleanup: Clean tools and excess material with soap and water before
recommended for exterior use or where moisture is likely. Do not it dries. Remove cured sealant by cutting with a sharp-edged tool.
use when temperature, glue or materials are below 50°F. Freezing Note
may not affect the function of the product but may cause it to thicken. Test solvent on a discreet area to make sure it will not mar or attack
Agitation should restore product to original form. Read MSDS the surface.
before using.
NOTE: STIR PRODUCT BEFORE USE TO ENSURE UNIFORMITY. LIMITATIONS
KEEP FROM FREEZING. Do not apply if rain is expected within 12 hours. Air, sealant and
surface temperature should be above 40°F. Allow at least 2 hours
of drying time before painting with acrylic or elastomeric coatings.
If joint depth exceeds 1/4”, use backing material. Not designed
for continuous submersion or use below the waterline. Do not use
for aquariums.
Dimensional data not binding. Dimensions in mm, inches are approximate. We reserve the right to alter specifications without notice.

Consumables and Tools

Size: 10.1 oz. cartridge
Size Item No. Color Item No.
1 gallon 003.15.101 white 003.55.050
5 gallons 003.15.102 clear 003.55.053
Note
Titebond UA 920 Clear (8741) will be white during application
but will clear within 7-14 days, depending on temperature,
humidity and bead size.
12

www.hafele.com/us FC 12.59